- Designed to line up with the duct extension where the original chassis was a flat-top discharge A-B Series
- Allows the existing duct adapter and extension to be used without requiring the relocation of the hole through the wall to the adjacent room
- Discharge grille, end plate and extension mounting hardware must be removed from old duct adapter and installed on the RAK7012
- Required for 5200 series 265/277 volt units
- Branch circuit plug to be used only in connection to appropriate sub-base
- 265/277 volts
- 3,450 heater wattage
- Required for 5200 series 265/277 volt units
- Branch circuit plug to be used only in connection to appropriate sub-base
- 265/277 volts
- 2,550 heater wattage
- Adapts chassis for use with older GE architectural grilles
- Aluminum deflectors are installed to the condenser end sheet flanges to prevent condenser airflow recirculation
- Allows some custom (non-standard) rear grilles to be used provided they have sufficient open area
- 230/208 Volts
- 5,000/4,090 heater wattage
- 30 Amps
